Skip to content

Lost-wax casting, from model to jewel

Almost all precious-metal jewelry manufacturing relies on the same technique, several thousand years old: lost-wax casting. A wax model is enclosed in investment plaster, the wax is burned out, and metal takes its place. Here is the full path, in order.

Get a quote

The model: carved, printed or injected

Everything starts from a model with exactly the shape of the piece you want. It can come about in three ways.

  • Carved: a wax cut and shaped by hand, for a one-of-a-kind piece.
  • Printed: a piece in castable resin, printed from a 3D model; see 3D printing.
  • Injected: a wax drawn from a mold, identical at every injection, for a series.

How to choose between hand and screen: carved wax or 3D model.

From wax to metal

Casting itself always follows the same order.

  1. Treeing: the models are attached by their sprues to a common wax trunk. The whole thing looks like a tree.
  2. Investing: the tree is placed in a metal flask, filled with refractory investment plaster. The plaster is vacuumed so that no bubble stays against the wax.
  3. Burnout: the flask spends several hours in the kiln, in stages. The wax melts, runs out, then burns away without residue; the plaster hardens and keeps the impression of each piece.
  4. Casting: the metal, melted at the temperature of its alloy, is poured into the still-hot flask. Vacuum or centrifugal force drives it into the finest details.
  5. Quenching: the flask is plunged into water. The plaster breaks apart and releases a tree of metal.
  6. Cutting: the pieces are separated from the trunk. The trunk and the sprues go back to the melt.

More on this step, the metals and how to prepare waxes: casting and preparing your waxes.

After casting

A piece that comes out of the plaster is a raw casting: matte, slightly rough, with the mark of its sprue. It becomes a jewel at the bench.

  1. Clean-up: the sprue is removed, the surface smoothed.
  2. Pre-polishing: the areas that will soon be hidden are polished.
  3. Assembly: the parts cast separately are joined.
  4. Stone setting: the stones are secured.
  5. Finishing: final polish and cleaning.

What the technique allows, and its limits

  • Free forms: hollow volumes, interlacing, relief, which forging or rolling cannot give.
  • Fidelity: the metal reproduces the wax down to the detail, even a fingerprint.
  • Repetition: with a mold, the same piece is made again identically.
  • Shrinkage: metal contracts as it cools; the piece is slightly smaller than its model.
  • Thicknesses: a very thin wall fills poorly, a heavy section can keep small porosity. Both are planned for on the model.

Frequently asked questions

Why is the wax said to be “lost”?
Because the model is destroyed during burnout. Each cast piece needs its own wax, carved, printed or injected.
Is a cast piece ready to wear?
No. It comes out as a raw casting and goes through clean-up then finishing before it shines.
Are gold, silver and platinum cast the same way?
The principle is the same, not the temperatures: pure silver melts at about 960 °C, pure gold at about 1,064 °C, platinum at about 1,770 °C. Platinum calls for a suitable investment and suitable equipment. See choosing an alloy.

Get a quote