Preparing a 3D file for printing and casting
A 3D file is printed, then cast, exactly as it is drawn: what is missing from the file will be missing from the piece. Five points to check before sending it.
What to check
- A closed volume. The mesh must have no holes and no open surfaces: the printer needs a solid, not a shell.
- The right units. Work and export in millimeters, at the real scale of the piece.
- Sufficient thicknesses. A wall or a prong that is too thin prints poorly and fills poorly in casting.
- An allowance for what follows. Clean-up and polishing remove a little metal: the finest details must allow for it.
- Stones at their true dimensions. Draw the settings and seats from the real dimensions of the stones to be set.
Exporting and sending
STL is the most common format for 3D printing. On export, too low a resolution leaves visible facets on curves; too high, it makes the file heavier without adding anything.
The form accepts .stl, .obj, .3dm and .step files up to 8 MB.
Frequently asked questions
- I have no file, only a drawing. Is that possible?
- Yes: that is what 3D modeling is for. A sketch or a photo is enough to send a request.
