Skip to content

Carved wax or 3D model: where to start

Two paths lead to the same casting: a wax worked by hand, or a model drawn on screen and then printed. The metal reproduces one just as it does the other. The choice depends on the piece, not on the casting technique.

Get a quote

Carved wax

Wax is cut, filed, scraped and shaped with heat. The volume can be seen and held in the hand throughout the work.

  • What it allows: free forms, textures, the gesture of the hand kept in the metal.
  • Its limits: perfect symmetry or two identical pieces take a great deal of skill; there is no file.
  • To make it again: you need a mold, taken from the cast piece.

The 3D model

The model is drawn on screen, then printed in castable resin. See 3D modeling and 3D printing.

  • What it allows: exact dimensions, strict symmetry, stone seats at the right size, the same piece in several sizes.
  • Its limits: the print layers sometimes leave fine lines, removed during clean-up.
  • To make it again: the file is kept, edited and printed again. See preparing a 3D file.

How to choose

  • A one-of-a-kind piece with free forms: carved wax.
  • Pavé work, calibrated stones, precise geometry: the 3D model.
  • A wedding band or a ring in several finger sizes: the 3D model, which can be resized.
  • A series: either one, then a mold.

Frequently asked questions

Is the finished piece different depending on the starting point?
No: casting reproduces a carved wax just as it does a printed piece. What changes is the design itself and the surface to be cleaned up after casting.
Can you go from a carved wax to a 3D file?
Yes, by 3D scanning. The resulting file often needs to be reworked before it can serve as a model.

Get a quote