Preparing your waxes for casting
Metal reproduces the wax down to the last detail, flaws included. A careful wax and a well-thought-out sprue avoid most rework.
The surface of the wax
Everything visible on the wax will show up in the metal: a scratch, a bubble, a burr, a fingerprint. It is far quicker to smooth a wax than to rework a cast piece at clean-up.
The sprue
The sprue is the path of the metal to the piece. Three principles guide where it goes:
- On the heaviest section: it sets last, and must stay fed by the sprue while the metal shrinks.
- Thick enough: a sprue thinner than the section it feeds sets before it does, and the piece shrinks in on itself.
- No sharp angle at the join: a rounded attachment guides the metal without turbulence.
The workshop’s exact requirements (condition of the wax, proportion of the sprue, length of the sprue path) are in the technical specifications.
Before drop-off
The drop-off deadline and the lead times are given in the workshop policy: receiving orders and production times. To plan the metal weight, the conversion table does the calculation from the weight of the wax.
Frequently asked questions
- Is a resin print prepared like a wax?
- The same principles apply to the sprue. The piece must be printed in castable resin: see 3D printing.
